Cisco Basic Administrative Configuration of a Router
Router> (This prompt indicates User mode or Non privileged mode)
Router > ? (This shows possible commands to be given from user mode)
Router > enable (This command will switch to Enable/Privileged/EXE mode)
Router # ‘#’ this prompt indicates that it is the enable mode.
Here the user can use any ‘show’ commands to view any file stored in NVRAM.
Router # show running-config (Will view the running configuration file stored in NVRAM)
Router #show startup-config (Will view the startup configuration file stored in NVRAM)
Router #show ip interface brief (Will display the ip information of all the interfaces briefly)
Router # show ip route (Will display the current routing table)
Router #show controllers s0/1 (This command is used to display the clock rate of an specific interface)
Router #show interface s0/1 (This command is used to display details of an https://www.cialissansordonnancefr24.com/acheter-cialis/ specific interface)
Router # configure terminal Will switch the user to global configuration mode
Router (config)# This prompt indicates global configuration mode.
For any configuration purpose user has to be in this mode.
Router(config)#hostname DHK Changes the hostname of the router
DHK(config)#